Keri-systems Doors.NET Manual Manual de usuario descargar pdf (Pagina 258)

100

101

Doors.NET Reference Manual

- 258 -

8. You can also see from the above image that a gateway IP address can be set to

the controller, thereby allowing communication across different LAN subnets.

9. Click the Accept button at the bottom of the Network Settings page.

10. The settings now need to be saved to the controller. Click the Apply Settings link

on the left, then click the ‘Apply Settings, Reboot’ button.

11. It will take approximately 20 seconds for the controller to fully reset and take on its

new IP address settings.

12. Click the Clear icon on the Scan Network page to remove the listed MSC controller

from the grid, then click Scan again. The controller will now be listed with the

newly assigned IP address.

13. Highlight the controller then click the Import button.

Memory Reset and Firmware Verification

1. The NXT-MSC controller is now listed in the hardware tree. Before configuring the

controller it must be reset by the software. This is indicated by the reset icon dis-

played beside the listing. Right-click the controller listing and choose Reset >

Memory. This performs the controller reset and a memory update.

2. A controller firmware revision check is then performed. The Status message grid

displays a “Correct Firmware” message for all controllers with current firmware.

3. An “Incorrect Firmware” message appears in the Status message grid if the con-

troller firmware is below the required revision. A firmware upgrade must be per-

formed for any controllers with this message.

1 2 ... 253 254 255 256 257 258 259 260 261 262 263 ... 601 602

Comentarios a estos manuales

Sin comentarios

Keri-systems Doors.NET Manual Manual de usuario Pagina 258

Comentarios a estos manuales

Relacionado con productos y manuales para Software Keri-systems Doors.NET Manual